TOWER KRIMP is for a curved roofing and crimped bends when required. This is possible on industrial profiles subject to the following parameters being observed:
• Radius of curvature (min 400mm).
• Minimum Lap of 300mm.
• Actual lap to suit requirements
TOWER KRIMP
For curved roofing and crimped bends
GENERAL INFORMATION
Applications
Replace fascia boards
Cover drive/walk ways
Eliminate the use of ridges
Enhance the aesthetics of a roof
CROSS SECTION
TECHNICAL SPECIFICATION
- 0.4mm to 1.4mm tolerance 10%
- Any length from 1.0m in steps of 0.5m to maximum of 12m
- Tile Red, Sky Blue, Bright Blue, Dark Green, Brick Red, Light Cream and Kraft Grey.
- Natural Aluminium – Other colours available on request (minimum 300m)